How To Install Integrated Washing Machine
Integrated washing machines are designed to fit in between kitchen cabinets and the counter top, providing an uncluttered appearance when not in use. Installing an integrated washing machine typically requires very few tools and roughly an hour of your time. If moving appliances is necessary, you will need additional help to lift heavy items, or you might just need a washing machine repair sheffield just contact us.
Before trying to install the new appliance please read the instruction book that came with your new appliance there are usually transit bolts and packaging inside the machine that will need removing before it can be used safely. Also make sure that the kickboard or plinth that goes around the bottom of your kitchen cupboards can be removed easily.
1, Is there enough room for the machine to be installed ?
Make sure there is enough room for the machine to be installed, the standard size of an integrated washing machine in the UK is 82cm high, 60cm wide, and 54-56 cm deep although there could be a slight difference between manufacturers. Please also bear in mind you will need to leave roughly 8cm between the back of the machine and the wall to allow for pipework.
2, Is the kitchen cupboard door in good condition and able to accept a new washing machine ?
The door will need to be in good condition and not damaged so that it can take the weight of the machine, if any hinges are stiff or difficult to operate you may consider changing them before install. Sometimes a washing machine install is made more complicated due to the cupboard being unsuitable for an install.
3, Is the plumbing and drainage and electric socket within easy reach of where the machine will be installed ?
You will need to install the washing machine near an inlet hose which is connected to a cold water supply if you don’t have this it can be easily installed but may involve moving the machine at a later date. It also needs to be near a drain outlet for discharge waste water or an existing drain that is suitable for the machine; many machines will use the same size drain pipe as your kitchen sink This outlet needs to be able to take the discharge flow of waste water from the washing machine. Also install near a power supply which you check using a plug socket tester.
4, Lift the washing machine out of its box and remove transit bolts and any other packaging.
5, Install The Feet
Carefully lay the machine on its side on a flat surface or follow manufacturers instructions in the pack you will have with the new washer, and install feet to bottom of washing machine using the correct size spanner (these are usually provided). These feet will be used when you are levelling up the machine.
6, Connect the fill hose.
Connect the fill hose (if not already connected) to the inlet at the back of the washing machine and check for leaks using a cloth.
7, Connect the drain hose.
Connect discharge hose drain hose (if not already connected) to the outlet on the back of your washing machine and install a stand pipe or connector if draining into a sink.
8, Connect the power cable.
Connect the power cable on the back of your washing machine to the socket where it will plugged in.
9, Place washing machine on level surface and adjust feet
Place washing machine on level surface and adjust feet (which were installed in step 5)
You should now test your install by filling your washing machine with water and running a few tests before fitting the washing machine to cabinet or cupboard.
Attaching the cupboard door to your washing machine install should be done with the hinge kit supplied with the washing machine, if there wasnt one please contact us and we will try and locate one for you.
If you install this on your own, please read the instruction book that came with the washing machine. Keep it somewhere safe so you can refer to it in future years
You’re done ! Congratulations !